MFTG4-16 Short Duration Test Generator at Mains Frequency per IEC 61000-4-16

The MFTG4-16 Short Duration Test Generator at Mains Frequency per IEC/EN 61000-4-16. The IEC / EN 61000-4-16 requires test stimuli at the frequency of the electrical power supply, either DC (positive & negative), 16 2 /3 Hz, 50 Hz or 60 Hz. For short duration disturbances the normal duration of this test is 1 second.

The MFTG4-16 was designed as an additional device to be used in combination with the power generator PLFCI4-16/19 or MFG-1000 to provide test levels up to 300 V with the lowest possible expenditure. In this case the MFTG4-16 is remote controlled via the application software of the PLFCI4-16/19 or MFG-1000 .

The MFTG4-16 may as well be used as a stand-alone device – application software is included. It´s signal output is single-ended and with galvanic isolation from the mains supply voltage and from the signal generator. 

MFTG4-16 Applications

EMC Standards

IEC/EN 61000-4-16 - Test for immunity to conducted, common mode disturbances in the frequency range 2 kHz to 150 kHz at a.c. power ports

MFTG4-16 Features

• Used for IEC/EN 61000-4-16 with LFCI4-16/19
• DC (positive & negative), 16 2 /3 Hz, 50 Hz or 60 Hz
• Immunity generator for short-term voltages at the frequency of the electricity supply (mains) up to 300 V
• Output power 1800 Watts
• Frequency Accuracy: 50 ppm
• Output Voltage Accuracy: 5%
• Over-heating Protection
• Application software via USB port