RFI Linear Positioners

Quick Links

Information

Viewed products

Maturo CGR 6.0 Cable...
6.0 m (without clamp) Moving range...

View larger

Maturo CGR 6.0 Cable Guide Rail

Condition New

6.0 m (without clamp) Moving range
6.6 m (with clamp) Total measurement length
Cable measuring guide rail
With the exception of the drive unit
Fabricated from plastic (PVC and reinforced fibreglass)
Metal parts are located only in the base plate
The drive mechanism (max. 0.3 m above ground level)
Used for the remotely-controlled positioning of an absorbing clamp along an electric cable

The EMC Shop

More details

Request Quote

Request Quote/More Info

Send to a friend
Send to a friend
Maturo CGR 6.0 Cable Guide Rail
6.0 m (without clamp) Moving range
6.6 m (with clamp) Total measurement length
Cable measuring guide rail
With the exception of the drive unit
Fabricated from plastic (PVC and reinforced fibreglass)
Metal parts are located only in the base plate
The drive mechanism (max. 0.3 m above ground level)
Used for the remotely-controlled positioning of an absorbing clamp along an electric cable
Recipient :
Name of your friend ^* :
E-mail address of your friend ^* :
^* Required fields
or Cancel
Print

PDF Downloads

Data Sheet

PDF Downloads (99.17k)

Test Equipment Description

The CGR 6.0 Cable measuring guide rail, with the exception of the drive unit, is fabricated from plastic (PVC and reinforced fibreglass). Metal parts are located only in the base plate and the drive mechanism (max. 0.3 m above ground level).

The Cable Guide Rail is used for the remotely-controlled positioning of an absorbing clamp along an electric cable. Automatic measurement of the RFI power according to CISPR, EN, ANSI, VCCI and VDE standards are possible.

The IEEE 488.2 (GPIB) bus provides an additional control option for all functions, when operated with the SCU/MCU or NCD Controller.

Technical Data
Moving range	6.0 m (without clamp)
Total measurement length	6.6 m (with clamp)
Overall length	6.8 m
Track height	0.8 m above floor
Permissible load	15 kg
Material	Plastic + reinforced fibreglass
Cross-section	100 mm x 100 mm
Base L x W	0.3 m x 0.3 m (with supporting pillars)
Positioning speed adjustable between	5.0 – 30.0 cm/s
Positioning accuracy	better +/- 1 cm
Motor	Brushless DC motor 200 W
Interference suppression	20 dB under limits EN 55022 class B
Current consumption	max. 2A
Voltage	208-230 VAC, 50/60 Hz, single phase
Discharge current	25mA per drive unit (higher in the moment when powering on)
Control cable	Fibre optic lines
Remote control via	IEEE interface
Antenna support drive	Toothed belt
Material of toothed belts	Kevlar reinforced (non-metallic)
Temperature range	+10 °C...+35 °C
Total weight	approx. 75 kg
Accessories	Interface for SCU/MCU/NCD Controller 3 m power supply cable Service manual