Send Enquiry For Solar Type 9124-1N Clamp On Current Probe, 1 kHz - 200 MHz
Solar Type 9124-1N Clamp On Current Probe, 1 kHz - 200 MHz
- Frequency range: 1 kHz - 200 MHz
- Transfer impedance (ZT): .001
- Continuous signal current (CW): 50 A
Cart 0 Product Products (empty)
No products
TBD Shipping
$0.00 + Shipping Total
Product successfully added to your shopping cart
Quantity
Total
There are 0 items in your cart. There is 1 item in your cart.
Total products
Total shipping TBD
Total + Shipping
MIL-STD-461 CS115
MIL-STD-461 CS115
CS115 Purpose
Conducted Susceptibility, bulk cable injection, impulse excitation
This test procedure is used to verify the ability of the EUT to withstand impulse signals coupled onto EUT associated cabling.
Test Equipment
The test equipment shall be as follows:
a. Pulse generator, 50 ohm, charged line (coaxial)
b. Current injection probe
c. Drive cable, 50 ohm, 2 meters, 0.5 dB or less insertion loss at 500 MHz
d. Current probe
e. Calibration fixture: coaxial transmiss
ion line with 50 ohm characteristic impedance,
coaxial connections on both ends, and space for an injection probe around the center
conductor.
f. Oscilloscope, 50 ohm input impedance
g. Attenuators, 50 ohm
h. Coaxial loads, 50 ohm
i. LISNs
Get Application Support, Pricing, Lead Time and More: Contact Form
MIL-STD-461 CS115 There are 27 products.
Solar Type 9124-1N Clamp On Current Probe, 1 kHz - 200 MHz
Typical Lead Time 4 - 6 Weeks- Frequency range: 1 kHz - 200 MHz
- Transfer impedance (ZT): .001
- Continuous signal current (CW): 50 A
Solar Type 9123-1N RF Current Probe 10 kHz to 500 MHz
Typical Lead Time 4 - 6 Weeks- Frequency range: 10 kHz to 500 MHz
- Transfer impedance (ZT): 1.0 to 5.0 Ω above 300 kHz
- Output load impedance: 50 + j 0 Ω
- Continuous signal current (CW): 40 A
- Maximum power current: 200 A DC to 400 Hz
Montena Turn Key Solution for MIL-STD-461 CS114, CS115, CS116 EMC Compliance
In Stock- Single generator output for CS114, CS115 and CS116 tests allowing remote test automation
- Automatic calibration for each test and for the full test frequency range
- Automatic configuration of the measurement equipment settings
- Built-in scroll-down menus for selecting test equipment and components
- Test and calibration reports automatically generated
