> Application/Test Type>Conducted Emissions>Analyzers, Receivers and Scopes
Analyzers, Receivers and Scopes

Most any signal or spectral analysis unit can be used to evaluate the quality of your electrical components and DUT's. Quasi peak detection and EMI filters are offered as options by many manufacturers. EMI Receviers and EMC analyzers have the required hardware and software to help identiry problem areas in both conducted and radiated applications, saving time on pre-certifciation and saving money but better identifing issues that may cause failure at the certification lab.

Analyzers, Receivers and Scopes There are 28 products.

per page
Showing 25 - 28 of 28 items
  • Quick view
    • FPC1000 Low-Cost Spectrum Analyzer for Emissions Testing
      • Frequency range: 5 kHz to 1 GHz, Upgradable to 2 GHz or 3 GHz
      • Resolution bandwidth settings down to 1 Hz
      • 10.1" WXGA (1366 x 768 pixel) display
      • Wi-Fi-enabled w/ remote control (included)
      • Easy virtual control w/ iOS/Android/PC
      • Low noise floor / High max. input power
      • Receiver mode for EMI debugging on circuit boards, integrated circuits, cable shielding, etc.
    • Teseq ISN T8 Impedance Stabilization Network (ISN) for Unscreened Balanced Pairs
      • For use with one, two, three, or four unscreened balanced pairs
      • Refers schematic circuit example in CISPR 22/32 Figure D.3/G.3
      • Intended for connection to cable category 3 and 5
      • 1000BaseT and PoE application
      • Changeable pin-arrangements with RJ11 and RJ45
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Rentals ship immediately
    • Monthly Rate Price
    • Current ISO 17025 Calibration Provided
    • Meets CISPR 16-1-1: 2010 and MIL-STD-461
    • Frequency Range: 20 Hz - 40 GHz
    • Configuration Includes:
      • B10: External Generator Control via GPIB
      • B18: Removable Hard Disk
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view

    • Sample Rates Up to 5 GS/s on All Channels
    • 10 Megasample Record Length on All Channels
    • 3,700 wfms/s Maximum Waveform Capture Rate
    • Built-in Ethernet Port



    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Basic DCV accuracy 75 ppm
    • Digits of resolution 6½
    • Max reading rate 300 rdgs/s
    • Memory 1,000 rdgs
    • DCV 100 mV to 1,000 V
    • ACV (RMS) 100 mV to 750 V
    • DCI 100 μA to 3 A
    • ACI 100 μA to 3 A
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
Showing 25 - 28 of 28 items