Rohde & Schwarz Ethernet Radiated Emissions Test Equipment Package

Rohde & Schwarz offers product sets for your EMC precompliance measurements, which include all necessary instruments to analyse typical EMC problems. Depending on your requirements, you can choose between a 1 GHz and a 3 GHz combination.

The Precompliance EMI Emissions Test Equipment Package includes all necessary instruments to analyse typical EMC problems. This set contains a spectrum analyzer FPC1000 and Teseq ISN T8.

Not only do unexpected results in test labs during EMC compliance measurements translate into extra costs, quite often they also cause a substantial delay for your project. Rohde & Schwarz offers effective and cost- efficient tools for EMC precompliance measurements which allow you to successfully prevent possible surprises before the actual onset of a problem.

Our HMExplorer software for your EMC measurements is included with every FPC1000 Low-Cost Spectrum Analyzer for Emissions Testing and Teseq ISN T8.

Set includes

FPC1000 Low-Cost Spectrum Analyzer for Emissions Testing
	Frequency range: 5 kHz to 1 GHz, Upgradable to 2 GHz or 3 GHz Resolution bandwidth settings down to 1 Hz 10.1" WXGA (1366 x 768 pixel) display Wi-Fi-enabled w/ remote control (included) Easy virtual control w/ iOS/Android/PC Low noise floor / High max. input power Receiver mode for EMI debugging on circuit boards, integrated circuits, cable shielding, etc.
Teseq ISN T8 Impedance Stabilization Network (ISN) for Unscreened Balanced Pairs
	For use with one, two, three, or four unscreened balanced pairs Refers schematic circuit example in CISPR 22/32 Figure D.3/G.3 Intended for connection to cable category 3 and 5 1000BaseT and PoE application Changeable pin-arrangements with RJ11 and RJ45