Com-Power CDN-M225E Coupling Decoupling Network for Unscreened Power Supply Lines

The CDN-M225E is designed for testing products that uses two conductor power cable. It has two 4 mm shrouded banana socket for both EUT and AE power connections. The CDN-M225E can handle up to 25 Amps AC and 17 Amps DC of current. The RF disturbance signal coupling port is female BNC. It can handle up to 40V of RF input Voltage. The bottom surface of the CDN is not painted for easy and effective grounding.

All Com-Power CDNs are individually calibrated. The Com-Power CDN-M225E fully complies with the requirement contained in the IEC 61000-4-6 and CISPR 16-1-2. All Com-Power CDNs can be purchased separately or as part of the CIS series conducted immunity test system. This is a pre-packaged solution that includes an ACS series power amplifier and all accessories required for the test.

Application

During conducted Immunity testing, CDNs are utilized to provide a means of coupling RF common mode signals to each line. In addition, CDNs provide the required common mode impedance to the EUT, isolation to the auxiliary equipment via common mode decoupling of the disturbance signals and provide uninterrupted communication between the EUT and auxiliary equipment.

Before you begin testing with the CDN-M225E you will need to establish calibrated drive levels corresponding to your desired test levels. During drive level calibration, the RF signal level being injected to the CDN is adjusted incrementally until the voltage level measured at the 150Ω to 50Ω adapter (ADA-515-2) connected to the EUT port is approximately equal to the Umr value given in the table below. The ADA-515-2 and accessories needed for this test are available from Com-Power.

Umr= Voltage level measured at the output of the 150Ω to 50Ω adapter (ADA-515-2)

Typical Data

CDN M-225E Accessory Kit:

• QTY 1: M225E Coupling/Decoupling Network
• QTY 2: ADA-M225E shoring adapters
• QTY 1: Calibration Certificate
• 3 Year Warranty
• ADA-515-2, 150 Ohm to 50 Ohm Adapter (Recommended Add-on - non-standard)
• TEP-050, 50 Ohm Terminator (Recommended Add-on - non-standard)