Com-Power LISN's

Quick Links

Information

Viewed products

Com-Power LI-3P-263...
9 kHz – 30 MHz Frequency Range 63...

Com-Power LI-3P-232 Three Phase LISN for CISPR / ANSI

View larger

Com-Power LI-3P-263 9kHz – 30MHz Three Phase LISN for CISPR / ANSI

Condition New

9 kHz – 30 MHz Frequency Range
63 Amperes Current Rating
Remote Switching of Line Under Test
Four-conductor Network appropriate for both 3Ø Delta and Wye Power Configurations
Three-Year Warranty

The EMC Shop

More details

Request Quote

Request Quote/More Info

Send to a friend
Send to a friend
Com-Power LI-3P-263 9kHz – 30MHz Three Phase LISN for CISPR / ANSI
9 kHz – 30 MHz Frequency Range
63 Amperes Current Rating
Remote Switching of Line Under Test
Four-conductor Network appropriate for both 3Ø Delta and Wye Power Configurations
Three-Year Warranty
Recipient :
Name of your friend ^* :
E-mail address of your friend ^* :
^* Required fields
or Cancel
Print

Specifications

Frequency Range	9 kHz – 30 MHz
Standards Met	ANSI C63.4, CISPR 16-1-2
RF Connector	RF Measurement Port 50Ω – N-Type (female)
Inductors	50 µH
Mains & EUT Connections	Remote Interface Power Input Port 5.5/2.5 mm Power Jack
Application/Test Type	Power Line Conducted Emissions Tests
Insertion loss	less than 0.7 dB
Isolation	more than 40 dB
Current rating	63 Amperes
Dimensions	19.3” x 13.9” x 2.3″
Weight	27.5 lbs.

Test Equipment Description

The Com-Power LI-3P-263 LISN provides the necessary measurement platform for performing power line conducted emissions compliance testing as required by most worldwide standards for commercial products. The LISN will perform each of the following functions during the measurement:

provide a defined, stable impedance across the measurement frequency range;
isolate the EUT and measurement circuit from the power source, thereby minimizing its influence on the measurements; and,
couple the disturbance voltages to the coaxial measurement port, which connects to the measuring instrument.

The LI-3P-263 LISN uses air-core inductors to prevent saturation and permeability variation. The mounting plates are left unpainted in order to facilitate connection to earth ground in their installation, which is essential due to high leakage currents. The side panels for the LISN are louvered for cooling purposes.

Standards	Met ANSI C63.4, CISPR 16-1-2
RF Connector	RF Measurement Port 50Ω – N-Type (female)
AC Voltage (maximum)	500 Voltsrms (line to line), 288 Voltsrms (line to ground)
DC Voltage (maximum)	705 Volts DC