> Top sellers

Categories

Quick Links

Information

Top sellers

per page
Showing 445 - 456 of 586 items
  • Quick view
    • Broadband - 100 Hz - 30 MHz
    • High Gain: 28 dB
    • Flat Response: ± 2 dB
    • Individual Calibration
    Request Quote
    Typically In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    $795.00
    • 2-5 Business Day Turnaround
    • Expedited Service Available
    • Data Available
    • Manufacturers Supported:
      • Teseq (Schaffner)
      • Haefely
      • EM Test
      • Noiseken
      • EMC Partner
      • Solar Electronics
      • 3ctest
      • and more...
    $795.00
    Add to cart
    2-5 Business Days
    Request Quote/More Info
    Add to Compare
  • Quick view
    • It consists of two identical channels for the lines "A" and "B".
    • It is constructed with air core inductors, in order to avoid intermodulation interference.
    • Frequency range of 9 kHz to 1 GHz can be measured.
    • Lower-frequency interference that may cause damage to the measuring receiver input shall be mitigated by additional high-pass filters.
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Combination of the Flat Elements 422 NJ with SBA 9119-Balun
    • Provides Remarkable Fieldstrength Levels with Moderate Transmit Power
    • With approx. 10 Watt transmit power one can reach fieldstrength levels of 300 V/m at a distance of 30 mm
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Elements for radiated immunity caused by hand portable transmitters
    • with SBA 9113 or SBA 9113 mini version for the Ford standard RI115 (Ford EMC CS 2009)

    Option:

    • Opt: Spacer 50
    • Spacer made of Polystyrene to set the 420 NJ elements test distance to 50 mm.
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Combined coupler for EFT/Burst and Surge testing
    • Surge as per ANSI/IEEE C62.41 (models CNI 501Bx only, other couplers on request)
    • LEDs indicate active mode and coupling
    • Automatic selection of Surge impedance
    • Fully remote controlled by EM TEST generators
    • Meet requirements up to 1,000V DC
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Test procedure acc. IEC 61000-4-6 Ed. 4
    • Built-in amplifier saturation and linearity check
    • Built-in power amplifier 25 to 80 watts, 10 kHz to 400 MHz
    • Built-in power meter, 9 kHz to 1 GHz
    • Built-in dual directional coupler
    • Automatic calibration via built-in power meter
    • Connection for external amplifiers up to 1 GHz
    • USB-Interface
    • Software for Windows 7, Windows 8
    Request Quote
    Typically In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Can be used in order to operate the ONYX
    • With Power from AC mains instead of operating the ONYX ESD Immunity Test System;
    • Unit via the Standard Battery Pack
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Rent Narda NBM-520 Kit
    • New - Old Stock
    • Intelligent probe interface detects probe parameters
    • Fully automatic zero point adjustment
    • Memory for saving up to 5,000 measurement results
    • PC software for convenient data management
    • Voice recording for comments
    • Conditional logging: Measured value saved when a threshold value is exceeded
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • As specified in IEC61000-4-6 (incl. edition 4 and EN 61000-4-6:2014)
    • Very Efficient Coupling
    • Can be used on almost any cable
    • Ruggedly designed
    • Improved locking system
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Broadband Frequency Range of 1 MHz - 1000 MHz
    • Low Noise Figure: less than 6 dB
    • High Gain: 33 dB
    • Low VSWR: 1.3:1 Max
    • Output Power: +4 dBm @ 1 dB compression
    • Flatness: ± 3 dB
    • Reverse Isolation: Greater than 30 dB
    • Impedance: 50 Ohms
    • Connector: N-type (f)
    Request Quote
    Typically In Stock
    Request Quote/More Info
    Add to Compare
  • Quick view
    • Rigol DSA710 100kHz to 1GHz Spectrum Analyzer
      • 100kHz to 1GHz Frequency Range
      • Displayed average noise level (DANL) <-155dBm/Hz typ. with preamplifier on
      • Minimum resolution bandwidth (RBW) 100Hz
      • Phase noise <-80dBc/Hz @10kHz offset
      • Level measurement uncertainty <1.5dB
      • 8" (800 x 480) high-definition display
      • Linear and logarithmic frequency axis
    • EMI-DSA800
      • For DSA800 Series Models
      • EMI Filter & Quasi-Peak Detector Kit
      • Option can be added by a software key
    • NFP-3
      • 30MHz to 3GHz Frequency Range
      • One set includes four types of probe, provides optimizing sensitivity and resolution
      • Minimum resolution: 2mm; able to capture near field radiation of single circuit line
      • Applicable for electromagnetic leakage testing inside the cable
    • S1210 EMIs
      • Introduces the workspace concept - Manage multiple measurements easily
      • 'Demo' mode included - Trial the software without an instrument and a licence
    Request Quote
    In Stock
    Request Quote/More Info
    Add to Compare
Showing 445 - 456 of 586 items