Teseq LNA 6018 Low Noise Amplifier 1 GHz to 18 GHz

The Teseq LNA 6018 is a low noise amplifier with typ. 22 dB of gain covering the nominal frequency range 1 GHz to 18 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments. All measuring instruments have a ‘noise figure’, which is a measure of how good the instrument is at measuring low level signals, the lower this figure, the better, although the lowest signal level will still be governed by the measurement bandwidth.

A typical spectrum analyzer may have a noise figure of 20 dB or more, whereas a typical receiver may have a noise figure of 10 dB. The preamplifier has a noise figure of typical <3.5 dB, significantly enhancing the low level performance of such instruments, enabling signals that were previously masked by noise to be seen. The low noise amplifier can be connected directly to the RF input (SMA) of the spectrum analyzer or EMI-receiver. The recommended power supply unit PSU 6018 is optionally available.

Features & Specifications of Teseq LNA 6018:

• Frequency range: 1 to 18 GHz
• Gain: typ. 22 dB
• Gain flatness: typ. ± 3 dB
• RF-Input: SMA - female, 50 Ω
• RF-Output: SMA - male, 50 Ω
• VSWR (input): ≤ 2.5 (typ. < 2)
• Noise figure: typ. < 3.5 dB (at 25°C)
• Max. input (linear): ≤ -10 dBm
• DC-power supply: 17 to 20 V
• DC-current: approx. 160 mA
• DC-connector: ODU-female, plus on inner conductors
• Operating temperature range: 0° to 40°C
• Storage temperature range: -20° to 60°C
• Size (W x D x H) (without connectors): 20 mm x 88 mm x 36 mm
• Size (W x D x H) (including connectors): 39 mm x 88 mm x 36 mm
• Weight: approx. 95 g
• Country code for mains connector: Euro, UK, US, JP, AUS
• Input: 100 to 240 V, 47 to 63 Hz, 400 mA
• Output: 18 V DC, 0.84 A
• DC-connector: ODU-male, 2 pins, plus on inner conductors
• Cable length: approx. 2 m
• Weight: approx. 220 g