Teseq NNB 51 Line Impedance Stabilization Network Dual-Line-V-LISN

Application

Line impedance stabilization network (LISN) such as the NNB 51 are used to measure distortion signals on the mains cord of an electrical equipment under test (EUT). The distortion signals are usually generated or picked up inside of the EUT and the mains cord acts as an antenna. European and international EMC regulations define maximum permissible signal levels and frequency bands for such distortion signals.

The distortion signal to be measured is available on a coaxial N‑connector that is mounted on the front panel of the NNB 51. For the actual measurement of the distortion signals a measuring receiver can be used. The V-network is part of a complex EMC-test setup that also has been standardized in CISPR 16‑2‑1 (EN 55016-2-1).

Features & Specifications of Teseq NNB 51:

• Standards applied: CISPR 16-1-2, MIL-STD-461, FCC Part 15,
• ANSI C63.4
• Frequency range: 9 kHz to 30 MHz
• Attenuator (build-in): 10 dB
• NNB operating voltage: 100 to 120 V / 220 to 240 V, 50 to 63 Hz
• EUT operating voltage: max. 250 V
• EUT frequency: DC to 63 Hz
• EUT phase detection function (LED): >48 V
• EUT operating current: max. 16 A
• Line impedance: 50 Ω || (50 μH + 5 Ω)
• Nominal output impedance: 50 Ω
• RF connector type: N female
• Artificial hand / connector type: 510 Ω + 220 pF / 4 mm banana
• Limiter: approx. 136 dBμV typ., switchable
• Artificial PE: switchable