RF Power Line CDN's

Quick Links

Information

Viewed products

Teseq CDN M416 4-Line...
4 power lines, (2L+N+PE), (3L+PE),...

View larger

Teseq CDN M416 4-Line Coupling/Decoupling Network

Condition New

4 power lines, (2L+N+PE), (3L+PE), optional (3L+N)
Frequency range: 150 kHz to 80 MHz
Designed for IEC/EN 61000-4-6
M4 application without PE
4 mm banana sockets
Power Rating: 250VAC/400VDC line to ground

The EMC Shop

More details

Typical Lead time: 4 - 6 Weeks

Request Quote

Request Quote/More Info

Send to a friend
Send to a friend
Teseq CDN M416 4-Line Coupling/Decoupling Network
4 power lines, (2L+N+PE), (3L+PE), optional (3L+N)
Frequency range: 150 kHz to 80 MHz
Designed for IEC/EN 61000-4-6
M4 application without PE
4 mm banana sockets
Power Rating: 250VAC/400VDC line to ground
Recipient :
Name of your friend ^* :
E-mail address of your friend ^* :
^* Required fields
or Cancel
Print

Specifications

Voltage Rating	AC max. voltage (line to ground) / (line to line): 250 V / 433 V (CDN M216-1000V: 500 V / 1000 V);DC max. voltage (line to ground) / (line to line): 400 V / 800 V (CDN M216-1000V: 1000 V / 2000 V);Test voltage: 3 kV DC, 2 sec
Frequency Range	150 kHz to 230 MHz (Optional 10 kHz - 80 MHz)
RF Connector	BNC, 50 Ω
Standards Met	IEC 61000-4-6, CISPR 16-1-2, CISPR 16-2-1 and CISPR 15
Mains & EUT Connections	4 mm, safety (Optional IEC 320 16A)
Common Mode Impedance	150 Ω +10/-20 Ω
Current Rating	10 Amps Maximum
Application/Test Type	3 power lines, (L+N+PE), (2L+PE), (Optional L+L+L)
Insertion Loss	Greater than 0.1 dB
RF Input Voltage	Less than 30 V
Decoupling of Common Mode Disturbance	Greater than 30 dB
Voltage Division Factor	20 dB ±1.5 dB
Dimensions	4.1 x 3 x 5 inches (10.5 x 7.5 x 12.5 cm)
Weight	700 grams (1.5 LB.'s)

Test Equipment Description

IEC/EN 61000-4-6 specifies the design and performance of a range of coupling/decoupling networks (CDNs). Each CDN is specific to the type of cable and the intended signal carried on the cable. Teseq offers an extensive range of CDNs which fully comply with the requirements of the standard and provide a simple and reliable method of injecting RF energy into the equipment under test (EUT).